Washing machine carbon brushes transfer electricity to the armature of the motor. The armature will then spin and the drum will turn via the drive belt. Washing machine carbon brushes are spring loaded in order that they are always touching the motor armature. Once they are worn to the point where contact is no longer possible the washing machine motor will not turn. Washing Machine Carbon Brush,Professional Washing Machine Carbon Brush,Washing Machine Motor Carbon Brush,Washing Machine Carbon Brush Motors,Washing Machine Carbon Brush Bushing Haimen Hailing Carbon Industry Co., Ltd. , http://www.carbonbrush-hl.com
Of course there are other components including electronics that are also responsible for motor rotation but worn carbon brushes are one of the most common reason for your washing machine drum to stop turning and spinning.
If your brushes are worn or damaged when you come to use your washing machine it will fill up with water, appear to sit idle for the duration of the wash and spin cycle (because the drum won't turn), and then drain out the water, and when you open the door of the machine to remove your clothes they will still be soaking wet!
You can find further help and advice here relating to other faults that can cause your washing machine drum to stop turning.
Discussion on the development prospect of plastic alloy floor heating floor
The advantages of plastic alloy floor heating floor are that traditional radiators cannot be compared. The inadequacies will be gradually compensated by the improvement of the quality of workers, the research and development of living grounds and the development of industry standard construction. As people's requirements for the built environment continue to increase, alloy plastic flooring will be more and more popularized in building heating.
The low-temperature hot water floor radiant heating system is heated by the PEX tube (heat medium 50-60°) or the heating cable buried under the ground, and the normal use is more than 50 years. However, if the heating temperature exceeds 75 ° C, the speed of aging of the heating coil is greatly accelerated, and the service life is shortened. The shortcoming of floor heating is that after the completion of the project, if it is found that there is leakage or the heating effect is not good, it is not easy to repair in the later stage. Therefore, in the whole process of low temperature hot water floor radiant heating system, scientific design and standard construction are required.
With the continuous development of “plastic-based steel†technology, the new plastic pipe not only reduces the cost, but also meets the requirements of temperature resistance, pressure, corrosion resistance and aging resistance. It has good comfort, high efficiency and energy saving, and does not occupy the room. The effective area, clean and hygienic, long use time, small maintenance, easy operation adjustment and heat metering. Plastic alloy floor heating is recognized as the ideal heating method and a promising heating method. Therefore, it can be seen that the development prospect of plastic alloy floor heating floor is quite broad.
Jiuzhi Plastics Network