With the improvement of living standards, wooden floors are more and more popular with consumers. Therefore, when the owners are refurbishing, they are paying more and more attention to the decoration process and acceptance of wooden floors. This is also to make home life more perfect in the future. General decoration white, it is difficult to see from the surface what is not on the floor laying unqualified places, today Xiaobian to teach everyone, how to practice eye-catching, easy acceptance floor! First, color If the color difference is too large, it has a direct impact on the beauty, you can require exchange (especially solid wood flooring and laminate flooring); if the color is too consistent, almost no color, it depends on the floor surface pattern is the same. In general, the patterns on the surface of solid wood flooring and reinforced wood flooring should be different for each piece, while the laminate flooring is the same pattern for each piece. Second, sound During acceptance, walk on the floor back and forth, focus on footsteps, pay more attention to acceptance in the area of ​​the wall and the door hole. If you find a part with sound, repeat the walk to determine the specific location of the sound, and then use chalk to mark. In this case, you can ask to remove the resurfacing. Third, deformation, warping This requires the use of tools. Acceptance method is to use a 2 meter long ruler, leaning on the floor, the flatness should not exceed 3 mm. Remember to measure a few more places. If the passing rate is above 80%, it is considered as qualified. In addition, you can touch the corner where the floor meets the floor by hand to see if it is flat. Floor acceptance Product introduction of internal forced expansion bolt: Drop In Anchor,Drop In Wedge Anchor,Drop In Anchor Fastener,Stainless Drop In Anchors Taizhou Risco Stainless Steel Products Co.,Ltd , https://www.riscofastener.com
The internally forced expansion bolt is easy and safe to install. It is applicable to fixed pipes, cables, heating equipment, ventilation devices, fire extinguishers, electric fans, sanitary equipment, flat steel and section steel, and ordinary steel structures.
*Body materials include stainless steel, carbon steel and other metal materials.
*Suitable for installation base materials: concrete, natural hard stone.
*This product is suitable for fixing by screws and internal teeth, installation of fire-fighting equipment, hot water pipe air conditioning and exhaust pipe, curtain wall, upside down pipe air duct ceiling, etc. in the heavy load range.
*The body is fully expanded with * * conical inner plug to be fixed in the base material, which is convenient and fast to install.
*The calibrated tensile value is obtained by testing under the condition of cement strength of 260 ~ 300kgs / cm2. The safe * * heavy load shall not exceed 25% of the calibrated value.
Grasp the five aspects of wood flooring inspection is not a problem!
1 2 Next> Total 2 Page
Page to page