Hydropower transformation, tiling, cabinet and door measurement and multi-level, in the process of decoration, the time used for hydropower transformation directly affects the start time of the program. Experts suggest that hydropower should be changed as little as possible. If there are no too special requirements, usually the water changes are small. Therefore, it is especially important to change the electricity less. First of all, it is best not to change the function originally set in the living space. Second, try to simplify the ceiling shape. Once the ceiling shape is complicated, in order to ensure the number of lighting and creating the atmosphere downlights and switches will increase invisibly, which will increase the difficulty and time of the wire. The summer decoration "toxic gas" doubled to shorten the construction period, and the hydropower was changed as little as possible. Summer decoration has higher requirements for the safety of hydropower materials. The materials used for the pipe, tape and other materials must be resistant to long-lasting high temperatures. At present, the galvanized iron pipe is mostly used for the wire pipe. If the quality is higher, the hot-dip galvanized iron pipe can be used to strengthen the strength and hardness of the material. The connector of the circuit is guaranteed by electrical safety. Long time high temperature can easily cause the insulating tape to fall off, which poses a safety hazard. If you want a better process, you can use a connector instead of a black tape to avoid the tape falling off at the joint. It doesn't matter if the rain is raining. Due to the special climatic conditions in summer, there are some details that require special attention. The first is the bricklayer. In summer, the temperature is higher and the water evaporates too quickly. If the material is not suitable, it is easy to crack and even fall off, so the requirements for bricklayers are relatively high. In order to ensure that the tiles are fully absorbent, it is best to soak them in advance, and then take out the water before picking up the water. After the surface is dried, it is necessary to carry out secondary soaking and use it while fishing, so that the tiles that absorb the moisture can be obedient. On the ground and on the wall. After tiling the tiled floor, it is best to cover it with a layer of cardboard, pour it through the water, then open the window and let it dry naturally. For the wall with the ceramic tile attached, if you encounter high temperature and do not rain for a long time, you should spray water regularly to make the tile dry slowly and stick more firmly. Followed by woodwork. She said that another characteristic of summer is that there are many heavy rains, and when the air humidity is high, it is easy to cause some wood products to be deformed. However, from the current decoration process, many wood products such as doors, floors, furniture, etc., are not processed on site, but are dehydrated in the constant temperature room of the factory and subjected to high temperature compression treatment. It is not affected by the season. For the wood-made products produced on the spot, there are some special requirements in the summer. Regular home improvement companies generally have a complete construction process system, and construction in strict accordance with these standards can avoid quality problems. Increased toxic gas release rate at high temperatures There is one of the biggest advantages in summer decoration, and whether the materials are environmentally friendly is easier to distinguish. Any building materials will have some pollutants. However, during the summer decoration process, the base layer such as wood boards is exposed, which can volatilize its pungent taste as soon as possible. After 7 or 8 months of high temperature drying, the impact on the subsequent use will be minimal. of. Summer is the season to accelerate the release of harmful substances such as formaldehyde in the air. From another point of view, it is beneficial to check whether the decoration materials are environmentally friendly. Taking wood materials as an example, when the temperature reaches above 28 ° C and the humidity exceeds 45%, the formaldehyde is released in multiples. At this time, the nose can be used to roughly judge whether the materials used by the main material or the decoration workers are environmentally friendly, and the materials with strong pungent smell are easily rejected. In addition, while the construction is carried out at this time, the release of poison gas is accelerated, so it is generally safer and more environmentally friendly to decorate and open the new home in the summer. “Summer paints work better.†Many people think that the rainy season will bring some trouble to the decoration, but in fact, unless there is rain for seven or eight consecutive days, it will have a certain impact on the decoration, that is, the paint is not easy. Dry out. But even if this happens, the problem is only an extension of the construction period. If it is very urgent, and want to catch up with the construction period, it is ok to let the workers blow the wall with an electric fan, and it will not affect the quality of the decoration. The benefits are: the summer temperature is high, the smell is easy to volatilize, the paint dries quickly, the sanding is timely, the gloss of the paint can be fully manifested, and the paint effect is best. Exterior Door Patio Doors,Storm Doors,Exterior Security Doors,Exterior Screen Doors Zhejiang JiHengKang (JHK) Door Industry Co.,LTD , http://www.zjjhk.com
Summer paint construction doubles toxic gas release
Jc001.load('iframe') JIFrame.create({ 'url' : '/go.php?action=ads&iframeHeight=250&isIframe=1&key=%CD%BF%C1%CF&pos_id=jc001_news_detail_30&reqkey=1&style=margin%3A15px+15px+ 25px+0%3B+height%3A255px%3Bwidth%3A255px%3B+float%3Aleft%3B', 'height' : 250 })