Rubber Seal,Alfas Rubber Seals,Viton Rubber Ring Gasket Neway Rubber Products Co., Ltd. , http://www.lxrubbers.com
Overview of stainless steel heat transfer pump installation steps
Stainless steel heat pump installation steps and heat transfer oil pump is basically the same, first of all, I want to remind everyone to pay attention to the stainless steel heat pump before entering the inlet and outlet pipe cleaning, the pump import section need to add filters to Anti-debris into the pump. The following is the installation steps: 1) The unit is placed on the foundation bolts buried in the base and put a pair of pads between the foundation, to find positive use; 2) Loosen the coupling, with a level instrument were placed on Pump shaft and base, by adjusting the wedge pad to make the unit to the level, after correction, the heat transfer oil pump properly tighten the anchor bolts to prevent ambulation; 3) with concrete pouring base and anchor bolt holes; 4) to be concrete dry After checking the base and the ground snail inspection whether there is a bad or loose phenomenon, the inspection should be tightened anchor bolts, and re-check the level of the pump; 5) to correct the coaxiality of the pump shaft and the motor shaft, Ruler test round the outer circle of the coupling shall not exceed 0.1 mm, the gap between the two coupling plane should be guaranteed between 2-3 mm, 90 degrees through the leveling feet when the coupling for calibration The other direction of the circle should not exceed 0.1 millimeters, the adjustment is generally relative to the pump to adjust the motor, flat point pad can be used to adjust the coupling method of coaxiality; 6) connected to the pipeline and determine the prime mover Turn the direction, then connect the coupling, and Check the concentricity of the outer circle of the coupling again; 7) make the final inspection after 3-4 hours of actual commissioning of the unit, if there is no bad phenomenon, then consider the installation qualified; 8) during the installation of stainless steel heat transfer oil pump, Objects fall into the machine, all the holes should be unit without cover.