The Barbed Wire is twisted and knitted by a fully automated barbed wire machine. The folk are commonly known as shovels, barbed wire, and barbed wire. Finished product type: Single wire twisted and double wire twisted. Raw materials: high-quality low-carbon steel wire.
Surface treatment process: electro-galvanized, hot-dip galvanized, plastic coated, sprayed.
There are blue, green, yellow and Other colors.
Used for grassland boundary, railway, highway and other isolation protection.
Barbed Wire Barbed Wire,Hot Dipped Barbed Wire,Pvc Coated Barbed Wire,Galvanized Barbed Wire Hebei Giant Metal Technology Co., Ltd. , https://www.wiremesh.pl
What should you watch out for when using a plastic mechanical mixer?
The previous Xiaobian introduced the advantages of the plastic mechanical mixer . Next, I will tell you about the things to be aware of when using the mixer:
1. After starting the machine, always pay attention to whether the various parts of the mixer are working properly. When stopping, always check if the blades of the mixer are bent and the screws are knocked down or loose.
2. The direction of rotation of the mixing drum should be in accordance with the direction indicated by the arrow. If it is not true, the motor wiring should be corrected immediately.
3. The mixer should be placed in a flat position, and the front and rear axles should be padded with square wood to make the tires stand up overhead so as not to shake when starting.
4. Check whether the transmission clutch and brake are flexible and reliable, whether the wire rope is damaged, whether the track pulley is good, the surrounding is unobstructed and the lubrication of each part.
5. The plastic mechanical mixer should be equipped with secondary leakage protection. After the power is turned on before going to work, it must be carefully inspected. It can only be used after passing the empty car test. During the test run, it should be checked whether the speed of the mixing drum is suitable. Under normal circumstances, the speed of the empty car (after loading) is slightly faster than 2-3 turns. If there is a large difference, the ratio of the moving wheel to the transmission wheel should be adjusted.
6. When the concrete is agitated or it is expected to stop for more than 1h, in addition to the remaining material, the stone and water are poured into the barrel, and the machine is turned and the mortar stuck on the barrel is washed out and completely discharged. There must be no water in the barrel to prevent the barrel and blades from rusting. At the same time, the ash accumulated outside the mixing drum should be cleaned to keep the machinery clean and in good condition.
7. After work and when the machine is not in use, the power should be cut off and the switch box should be locked to ensure safety.